Back to Chimney Repair

Services

Partial and full chimney rebuild

Taking a failed stack down to sound masonry and rebuilding it, scoped from an inspection.

5.0 from 168 Google reviews 24 hours, by appointment

Chimney Rebuild Drawn from the standard. This is a drawing and no reading on it is live.

Drawn from the standard. This is a drawing and no reading on it is live. Chimney failure concentrates above the roofline, where the stack is exposed on four sides with nothing sheltering it, so a rebuild usually starts there rather than at the base.

Sheet 03I, Chimney Repair

Scope

What this covers

A rebuild is what is left when repointing can no longer hold a stack together. The masonry is taken down to sound material and rebuilt from there, either above the roofline, which is where most failure is concentrated, or the full height where the damage runs into the structure below. It is the largest job in this section and the one to get a second opinion on, so the scope is written down before any figure is attached to it.

  • Inspection first, to establish how far down the failure runs
  • Partial rebuild from the roofline up, where the structure below is sound
  • Full height rebuild where the damage continues into the masonry below the roof
  • A new crown, cap and flashing built into the rebuilt stack, never added as extras
  • Salvage or matching of brick so a rebuilt stack does not read as a repair
  • The scope written down and the work scheduled with the team against it

Detail

Three ways a stack ends up here

A rebuild is almost never a surprise. It is the end of a sequence that started with water somewhere above.

Photograph

Photographs of our own jobs are added here as they are taken. Until then the frame carries a drawing, not a borrowed picture.

Long term water
A failed crown or open joints let water in for years, freeze and thaw pushed the masonry apart, and repointing is now holding brick that has nothing left behind its face.
Movement
A stack leaning, separating from the house, or cracked vertically through several courses. That is structural movement and not weathering, so it is written up as a finding.
An event
A chimney fire, a storm, an impact or a lightning strike. All of these are named triggers for a level 2 inspection, and a rebuild that follows one is usually an insurance conversation as well as a construction one.

Common questions

What people want to know before booking

How do I know a rebuild is needed rather than repointing?

When the units have failed and not the joints, when the stack is out of plane or leaning, or when so much of the brick face has spalled that replacing it amounts to most of a rebuild anyway. An inspection establishes which of those it is, and the finding is written down with photographs so it can be taken to another company.

What is the difference between a partial and a full rebuild?

Where it starts. A partial rebuild takes the stack down to the roofline, or to sound masonry above it, and rebuilds from there. A full rebuild continues below the roof, and it is a much larger job because it involves the structure inside the house as well as the exposed stack.

How is this work arranged?

It is inspected first, scoped from that inspection, and then scheduled against the scope. Nothing is quoted before the inspection, and a rebuild is not work that starts on the day someone first looks at the chimney.

Does the rebuild include the crown and the cap?

Yes. A rebuilt stack gets a new crown with an overhang and a drip edge, a cap sized to the flue or flues, and the flashing reset where the new masonry meets the roof. Rebuilding a chimney and reusing the crown and flashing that failed on the old one puts the same fault back on new brick.

The method

Why the failure is usually above the roof

The section of a chimney above the roofline is exposed on four sides, has no eave over it and no heated structure around it, and takes every drop of wind driven rain the weather sends at it. Below the roof the same masonry is sheltered, partly inside the building envelope and much warmer. That is why a stack can be crumbling at the top and sound in the attic, and why a partial rebuild from the roofline up is usually what the report calls for.

What a rebuild involves

The failed masonry comes down course by course to material that is sound. Brick is salvaged where it can be and matched where it cannot, because a rebuilt stack in a different brick reads as a repair from the street for the life of the house. It is rebuilt to the original dimensions unless the inspection gives a reason to change them, the flue is reset or relined as the report requires, and it is finished with a new crown, a cap and flashing. Access is scaffolding or a roof platform, never a ladder, and it is a real line in the estimate.

The cost question, answered as far as it can be

A rebuild estimate is built from five things: access and scaffolding, the height and width of the stack, whether the rebuild is partial or full, whether the flue is being relined at the same time, and the brick. No price band is published here, because those five vary more than any figure printed on a page could carry. They are what the written estimate itemizes, and any number given before someone has been on the roof is a guess.

Get a second opinion

A rebuild is the chimney job with the most room between a necessary scope and an aggressive one. The findings are written down with photographs so another company can price the same scope.

Insurance and a rebuild

Where the rebuild follows a storm, an impact, a lightning strike or a chimney fire, there is usually a claim behind it. This business documents the damage with photographs and readings, so you have a complete file to give your insurer. It does not file, adjust or negotiate the claim, and it does not tell a homeowner what a policy will pay before the carrier has said so.

What comes after

A rebuilt stack is new masonry with new mortar, and it goes into the same weather that took the last one down. Waterproofing once it has cured, an annual inspection, and a crown and cap that were built to shed water are what stop the sequence starting again. A chimney that fails early usually failed because a water path at the top stayed open for years.

Before you call

Frequently asked questions

Question 1: When does a chimney need rebuilding rather than repointing?

When the brick has failed and not the mortar, when the stack has moved out of plane, or when replacing the spalled units would amount to most of a rebuild anyway. An inspection establishes which, and the finding is written down with photographs so it can be checked against a second opinion.

Question 2: What is a partial chimney rebuild?

Taking the stack down to the roofline, or to sound masonry above it, and rebuilding from there. It is usually what the inspection calls for, because the section above the roof is exposed on four sides with no shelter and takes the weather that causes most chimney failure.

Question 3: How much does a chimney rebuild cost?

No price band is published here. The figure is built from access and scaffolding, the height and width of the stack, whether the rebuild is partial or full, whether the flue is relined at the same time, and the brick. Those items appear on the written estimate, which is free and comes after the inspection.

Question 4: Do you rebuild chimneys in house?

The inspection, the findings and the written scope are this team's own work. Who lays the brick is named in the written estimate before anything is scheduled, so you know before you sign.

Question 5: Does a rebuild include a new crown and cap?

Yes. A rebuilt stack is finished with a crown that overhangs and has a drip edge, a cap sized to the flue, and flashing reset where the masonry meets the roof. Reusing the components that failed on the old chimney puts the same water path back on new brick.

Customer reviews

5.0 from 168 Google reviews, opens in a new tab
“I was impressed by DHL's prompt service and expertise. They efficiently handled my water damage issue, and the results were excellent. Great communication throughout the process!”
Viviana Gil · · 5 stars on Google,

“We had an unexpected shower leak due to an incorrect installation by the previous owners. The team arrived the SAME DAY to diagnose the issue, and within 24 hours, the repair crew was on-site to resolve the problem.”

Kaiden Braxton · ·

“DHL did a fantastic job restoring our home after water damage. They were efficient, communicative, and the results are amazing. Thank you!”

Yohnny Cambero · ·

Read them all on Google, opens in a new tab

Coverage

Where we do this

We cover six counties across North and Central New Jersey. All services are performed at your home or business.

Towns we cover

Estimate request

Tell us what needs cleaning

Tell us the rooms, the surfaces and the address, and attach a photograph of the affected area if you have one. You receive a written estimate before any work begins, with no obligation.

Written estimate, no obligation Answered any hour at (908) 520-8698 5.0 from 168 Google reviews EPA-registered products, safe for pets and children

Written estimate

NO. 0168
A written estimate before any work begins, with no obligation.
Please enter your name.
Enter a 10 digit phone number.
Enter a valid email, or leave it empty.
Enter the street address.
Enter the town.
Enter the 5 digit ZIP.
What needs cleaning? (pick at least one)
Pick at least one surface.
Photographs of the area (optional, up to 5, 8 MB each)

A photograph of the area helps us give an accurate estimate.

    The estimate is free and there is no obligation.

    NORTH JERSEY · N.J. ESTIMATE · IN WRITING RECEIVED NO. 0168

    Request received.

    Your written estimate comes back from the technicians who do the work. For anything urgent, call (908) 520-8698.

    Get my estimate